EC 120
SB 76-007 ENGINE CONTROL – Lock assembly Modification to the setting of the twist grip locking pin
SB 05-013 TIME LIMITS – MAINTENANCE CHECKS – Engine starting – SKURKA (ex APC) starter-generators (MP/N) 160SG140Q1 and 160SG140Q1XL
ASB 52A014 DOORS – Sliding door Attachment of the sliding door star support
IN 2542-I-00 GENERAL-Any installation comprising frangible disks/Incorrect reinstallation following a test
IN 2526-I-60 STANDARD PRACTICES – ROTORS – Check of the electrical continuity of Gear Box Magnetic Plugs
TIP 34-30-01 GTX330 (MODE S) GARMIN TRANSPONDER – Comply with regulations
AS 350
SB 01.00.66 LIMITATIONS Removal of the additional chin weights and addition of a load compensator on the yaw channel on helicopters which are POST modification 075601 and equipped with an Arriel 2D engine
SB 64.00.11 TAIL ROTOR – Tail rotor blades Modification of the chin weight support to avoid any interference with the laminated half bearings
“E”ASB 01.00.65 LIMITATIONS Speed limitation and check of Tail Rotor laminated half-bearings (Helicopters POST MOD 07 5601 equipped with Arriel 2D engine and PRE MOD 075606)
“E”ASB 05.00.71 TIME LIMITS – MAINTENANCE CHECKS – Check of the Tail Rotor laminated half bearings
IN 2333-I-28 FUEL – Flowmeter Obsolescence of the battery
IN 2542-I-00 GENERAL-Any installation comprising frangible disks/Incorrect reinstallation following a test
IN 2526-I-60 STANDARD PRACTICES – ROTORS – Check of the electrical continuity of Gear Box Magnetic Plugs
IN 2533-I-21 AIR CONDITIONNING – Heater pipe rupture causing wire bundle melting
TIP SH96-126 STC: BLADE TIE-DOWN PROVISIONS – Easy blade tie-down installation
TIP 25.50.05 ELECTRIC REAR-VIEW MIRROR WITH ANTI-ICING SYSTEM – Keep an eye on the sling!
TIP 34-30-02 GTX330 (MODE S) GARMIN TRANSPONDER – Comply with regulations
SIN 2541-S-29 HYDRAULIC POWER – New hydraulic pump drive (POST MOD 07-9566)
EC 130
SB 53-022 FUSELAGE – Fenestron Improvement of tail prop assembly
SB 53-017 FUSELAGE – Reinforcing the tail boom / Fenestron riveted junction
SB 05-010 TIME LIMITS – MAINTENANCE CHECKS – Engine starting – SKURKA (ex APC) starter-generators (MP/N) 150SG122Q and 200SGL130Q
ASB 52A009 DOORS – Sliding door Attachment of the sliding door star support
IN 2542-I-00 GENERAL-Any installation comprising frangible disks/Incorrect reinstallation following a test
IN 2526-I-60 STANDARD PRACTICES – ROTORS – Check of the electrical continuity of Gear Box Magnetic Plugs
TIP 25.50.02 ELECTRIC REAR-VIEW MIRROR WITH ANTI-ICING SYSTEM – Keep an eye on the sling!
TIP 25-60-13 EMERGENCY FLOATATION GEAR – The essential installation for flight over water
SIN 2541-S-29 HYDRAULIC POWER – New hydraulic pump drive (POST MOD 07-9566)
AS 355
SB 05.00.64 TIME LIMITS – MAINTENANCE CHECKS – Engine starting – SKURKA (ex APC) starter-generators (MP/N) 150SG111Q, 150SG117Q and 150SG117Q-1
“E”ASB 05.00.63 TIME LIMITS – MAINTENANCE CHECKS – Check of the Tail Rotor laminated half bearings
IN 2333-I-28 FUEL – Flowmeter Obsolescence of the battery
IN 2542-I-00 GENERAL-Any installation comprising frangible disks/Incorrect reinstallation following a test
IN 2526-I-60 STANDARD PRACTICES – ROTORS – Check of the electrical continuity of Gear Box Magnetic Plugs
TIP 34-30-03 GTX330 (MODE S) GARMIN TRANSPONDER – Comply with regulations
TIP 25-60-02 EMERGENCY FLOATATION GEAR – The essential installation for flight over water
EC 135
SB 85-056 OPTIONAL EQUIPMENT – Cargo Hook/External Mirror Mounting Assembly – Retrofit of a water drainage hole on the external mirror mounting assembly
SB 71-041 POWER PLANT – Sand Filter – Retrofit of the operating hours counter for the sand filter blower motors
ASB 22A-015 Auto Flight System – Longitudinal, Lateral and Yaw Actuator – Check SEMA/control rod for correct attachment hardware
ASB 85A-044 OPTIONAL EQUIPMENT – Cargo Hook – Replacement of placards
IN 2535-I-28 FUEL SYSTEM – Water contamination of the Fuel System – Notes about possible water contamination of the fuel system
IN 2526-I-60 STANDARD PRACTICES – ROTORS – Check of the electrical continuity of Gear Box Magnetic Plugs
TIP Pricelist 2013
TIL EC135 039-2012
SIN 2504-S-22 AUTO FLIGHT SYSTEM – Vertical vibrations related to balance weights
SIN 2521-S-63 Main rotor drive Measures after chip detector indication
AS 365
IN 2333-I-28 FUEL – Flowmeter Obsolescence of the battery
IN 2542-I-00 GENERAL-Any installation comprising frangible disks/Incorrect reinstallation following a test
IN 2526-I-60 STANDARD PRACTICES – ROTORS – Check of the electrical continuity of Gear Box Magnetic Plugs
SIN 2536-S-25 EQUIPMENT AND FURNISHINGS – Check of the seat belt fastener attachment fitting
BO 105
IN 2526-I-60 STANDARD PRACTICES – ROTORS – Check of the electrical continuity of Gear Box Magnetic Plugs
BK 117
SB 60-125 POWER PLANT – Vent Lines – Improved connection of the forward and rear vent lines
IN 2526-I-60 STANDARD PRACTICES – ROTORS – Check of the electrical continuity of Gear Box Magnetic Plugs
